70050
Ultimate LS ECU & Harness Standalone Kit
$959.00
Part Number: 70050
In stock
This product falls under the following Emissions Category:
WARNING: Hazardous Material Warning Close WARNING: This product can expose you to chemicals including Nickel Acetate, Chromium, Lead, Lead Compounds, Nickel (Metallic), Nickel Compounds, Diisonyl Phthalate (DINP) and Toluene which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Description
If you’re considering utilizing a factory intake, injectors, and cable operated throttle body, FiTech’s Ultimate LS standalone self-learning ECUs will get your engine ready for optimal performance. This self-learning Ultimate LS ECU is the best solution for a standalone LS swap and replaces the OEM computer and harness. This kit is dedicated to LS or similar engines with crank and cam sensors. The Ultimate LS standalone kit will self-learn to most cam swaps. Usually only very large cam grinds will require additional tuning in the system. Easily tuned for even the most novice tuner, this kit includes a touch-screen controller for easy setup and configuration.
- Application: LS or similar engines with crank and cam sensors.
Small Block V8 GEN. III/IV LS-based Chevrolet street and performance engines. Contains a 3 BAR MAP sensor for power adder applications that supports up to 30 PSI of boost. - Note: This kit does not work with drive by wire throttle bodies and variable valve timing. These engines can be modified to remove these components.
Not legal for use on pollution controlled vehicles: FiTech’s Ultimate LS System is not approved for use on emission controlled vehicles. This system is designed to control the EFI and ignition on LS based engines being retrofit into older vehicles that do not require emission controls.
Features
- Self-learning ECU with touch screen controller for easy setup and configuration.
- Sequential fuel and spark control with individual cylinder trim.
- 3 BAR MAP sensor automatically detects up to 30 psi boost.
- Stainless O2 Sensor bung (clamp or weld on).
- 24X and 58X crank and cam compatible.
- Two programmable fan control outputs.
- Tach output driver for most tachometers (5V).
- Output driver for most speedometers.
- Compatible with car and truck coils.
- On the fly programmable target AFR and timing (if desired).
- Fuel pump relay output.
- Custom wire harness (uses factory coil pack sub harness).
- Knock sensor control.
Kit Contents
- LS ECU.
- Plug and play primary wiring harness.
- Hand-held controller with color touch screen and cable.
- Windshield mount for touch screen controller.
- 3 BAR MAP Sensor.
- O2 Sensor.
- Stainless Oxygen Sensor bung kit (Clamp or weld on).
- Two programmable fan control outputs.
Additional information
Weight | 11.5 lbs |
---|---|
Dimensions | 14 × 7.5 × 10.5 in |
Additional information
Weight | 13 lbs |
---|---|
Dimensions | 15 × 9 × 12 in |
Related products
-
70073
$965.00
Loaded LS3 Aluminum Intake Manifold 500HP KitIn stock
Add to cart -
70065
$483.00
LS3 Short Aluminum Intake Manifold w/ RailsIn stock
Add to cart -
70016
$2,107.00
Ultimate LS7 500HP Square Port Kit w/ Trans ControlIn stock
Add to cart -
70017
$2,107.00
Ultimate LS7 750HP Square Port KitIn stock
Add to cart