-
-
FiTech EFI – Nitrous Instructions
N2O Solenoid Control If the ECU is to be in control of the relay that drives the solenoids, set this accordingly. N2O ENABLED If the ECU is used with a nitrous system, set this accordingly. N2O Signal Level If the signal that tells the ECU to enable nitrous is a +12V signal, or a grounding…
-
Handheld Controller Feature Definitions
OPTION Coil Drive These are the primary things to adjust to set up the ignition control system. Distrib Base deg = Adjust this so that the displayed timing matches the actual timing seen on a timing light at low RPM, such as idle, or adjust the distributor so that the timing light matches the display. It’s…
-
FiTech EFI – Basic Setup Instructions
These are a basic overview of the most common setup questions. Resetting to a Stock Calibration From the main menu, go to the very bottom and select Write Cal To ECU. Once in this menu scroll down to the second to last selection, it should say Default v8 T195. Once on this file select it,…
- « Previous
- 1
- …
- 9
- 10
- 11